A hole is drilled, a little smaller than the stone to be set trough the piece of jewelry. After enlarged and a bearing is cut, where the stone can rest. When all preparation work is done, the stone is placed into the open and hammered until, he sit in fix position. With a burnisher the edge of open metal is worked on.Until the stone sit strong in place. Afterwards the metal is sand papered until the surface is the same than the rest of the
piece.
Not very often used setting, most for smaller round stones.
:: Link
:: |
||
Info |
:: |
Picture |
:: |
Prong | |
:: |
Bezel | |
:: |
Gypsy | |
:: |
Channel | |
:: |
Pavee | |
:: |
Invisible | |
:: |
Tension | |
